Hi Patili,
glad to hear that your problem is solved.
I hope your clinic is growing with the same success.
Regards,
Detlef
FiveTech Software tech support forums
www.FiveTechSoft.com
ERROR 5300
18 posts • Page 2 of 2 • 1, 2
by Detlef Hoefner » Thu Mar 06, 2008 12:20 pm
-
Detlef Hoefner - Posts: 312
- Joined: Sat Oct 08, 2005 9:12 am
- Location: Germany
by James Bott » Thu Mar 06, 2008 6:59 pm
Patili,
Glad to hear you solved it. I don't think Clipper can hand UNC paths, so that it probably what was causing the error. You could also probably map the server.
I saw that Harbour has a lib called hbsix.lib. I don't know if this is the HyperSix RDD (Harbour version) you need, but you might ask over on the xHarbour newsgroup.
James
Glad to hear you solved it. I don't think Clipper can hand UNC paths, so that it probably what was causing the error. You could also probably map the server.
I saw that Harbour has a lib called hbsix.lib. I don't know if this is the HyperSix RDD (Harbour version) you need, but you might ask over on the xHarbour newsgroup.
James
-
James Bott - Posts: 4840
- Joined: Fri Nov 18, 2005 4:52 pm
- Location: San Diego, California, USA
18 posts • Page 2 of 2 • 1, 2
Return to FiveWin for CA-Clipper
Who is online
Users browsing this forum: No registered users and 5 guests