GET...ACTION Bug?

[byte-one]

If i use a ACTION-Button in a get and switch this get to disable, the position of the text inside are moving to center of the get and is not full visible because the action-button is over!
The position from the text(variable) on disabled status of the get should be on same place as in enabled status!!

[nageswaragunupudi]

I tested just now and did not notice this problem. The text in the Get is displayed at the same position whether active or disabled.
Can you please provide a small sample?

[byte-one]

Mr. Rao, i tested and found that this is only when in the RC-file the get is marked as "center". "left" and "right" seems ok!

[nageswaragunupudi]

Thanks.
So, glad to know it is not a bug in TGet.

[byte-one]

Mr. Rao, in the case of "center", the disabled get should also displayed centered between left and the action-button. Now the width of the get are calculated inclusive the width of the action-button. This is wrong.

[nageswaragunupudi]

So, this is what you mean.

These Gets are alternately enabled and disabled. They are not aligned exactly the same way.
We will look into this.

[nageswaragunupudi]

Fixed in FWH 18.01

[byte-one]

THANKS!