- Code: Select all Expand view
Local oHttp:=TIpClientHttp():new("https://www.testserver.com/1", .F. )
IF .NOT. oHttp:open()
MsgAlert( "Connection error:", oHttp:lastErrorMessage( ) )
RETURN
ENDIF
oHttp:Post( cXml)
cRet := oHttp:readAll( )
oHttp:close()
This code works fine with xHarbour.com, and with my FWH / Harbour / VC 2013 builds ( using UE Studio makefile ).
It also builds inside Visual Studio 2013. However, when I try to then start the program in which it is linked, I get an error:
The procedure entry point BIO_clear_flags could not be located in the dynamic link library ..... ( the path to the .exe I'm trying to run ).
By commenting out just this code, all is fine.
My build uses hbtipssl.lib which is where I believe the class is contained. Perhaps there is another library that I should be using for this to be OK.
Any ideas on this issue would be greatly appreciated. Also, any suggestions for an althernative approach would be appreciated.
Using FWH 14.06 / Harbour / Visual Studio 2013 Pro.
Thanks everyone.
Tim